About this deal
EDIT2: After some googling I came over another device driver and tried it. It seems to work: https://drivers.softpedia.com/get/KEYBOARD-and-MOUSE/LOGITECH/Logitech-Flight-Instrument-Panel-Driver-8-0-124-0-64-bit.shtml Activate Developer Mode : Chrome -> "Settings" -> "More Tools" -> "Extensions", and move the "Developer mode" slider in the top right corner. When I start Spad.next, it says “The FIP with Serial MZXXXXXXXX could not be found. This is most likely because the Saitek FIP Drivers are not installed.” It displays this message for each of my 6 FIPs. The other Logitech products work fine.
Is there something I have missed? Please help, no fun flying now that I have gotten used to my setup… Any data from HWInfo can (optionally) be displayed. This also works when Elite Dangerous is not running.EDIT: I have powered HUBs, both USB2 and USB3. I also started Spad.next as administrator. The only warnings Spad.next displays is about the missing device drivers. I just upgraded to a new PC from an old where everything worked fine and for some bizarre reason, the FIP panels are not recognized by Windows on my new PC. Use the left rotary encoder or the S5/S6 buttons to show another card on various tabs or zoom into the galaxy map. Leftmost number on lower LCD row (0x0-0x9, 0xA above will darken the digit position, except 0xEE which will show a dash) DCSFlightpanels communicates with DCS using DCS-BIOS, the brainchild of [FSF]Ian. [FSF]Ian has been very helpful in answering questions and helping out during the development process. His contribution to DCS will change the user experience from now on for a lot of us. If you get the chance then say "thanks" and give him some positive rep!
b]Close down DCS, delete all logs under C:\Users\
You can use several panels of the same type and have different mappings on each except Radio Panel which is fully programmed by DCSFlighpanels DCS-BIOS, if you are using DCS-BIOS then make sure the setting DCS-BIOS json location points to the correct folder. Usually the default setting is correct but if you are using DCS openbeta then you will have to change this. Tried to create this panel, for controlling MFD.