FireAngel CO-9X-10T-FF Carbon Monoxide Alarm, Multi

Product Information

If your FireAngel carbon monoxide alarm is new and the test button is not working, try removing the isolation pin. Once removed, wait for at least 1 minute for alarm to initiate. If the alarm now sounds once test button is pressed your alarm is working correctly. If it still does not sound, please get in touch with our Customer Support team. If you have had your FireAngel carbon monoxide alarm for a few years but it is still within warranty, and the isolation pin has been removed, please get in touch with our Customer Support team. If it is not within warranty, please replace your alarm as soon as possible. Why is my FireAngel CO alarm beeping? CO detectors should be installed near potential sources of carbon monoxide, essentially any fuel-burning appliances such as boilers, cookers and ovens, fireplaces (both open and enclosed burners), and portable generators. As you are likely to be most affected by CO in areas of your home that you spend the most time in it is advisable to install alarms in those areas as well, such as the living room and bedrooms. It is also worth noting that while one detector is better than no detectors at all, larger homes may require several detectors to cover the property fully. To activate your CO alarm, pull the disabling tab out of the alarm and wait up to 1 minute for the green LED to flash to confirm the alarm is active. After 1 minute, press the test button to hear the alarm sound. Please note, the alarm will not sound before the 1 minute activation period is complete. CO alarms and rental properties The 7 year sealed battery powered FireAngel CO-9X carbon monoxide alarm features clear LED indicators for power, fault or alarm status and a large test/reset button for ease of testing the device. The CO detector can be wall mounted for home use, or can be left free standing, making it a suitable portable detector to take on holiday.

Once your CO alarm is activated and tested, choose to install the alarm by mounting on a wall or free standing on a shelf. Your alarm should be placed 1-3 metres away from any fuel burning appliance in your home, in living rooms or bedrooms.

Key Product Features

The FA3820X4 Carbon Monoxide Alarm offers a variety of safety features, including Ventilate Instruction, Alarm Memory, Sleep Easy and Quiet Self Test. In living spaces: they should be positioned close to where the occupant's head is likely to be most of the time – e.g., on your bedside table.

CE marked and Kitemarked to BS EN 50291-1 (domestic use) & BS EN 50291-2:2010 (camping/caravans/boats) With a multi-functional LCD digital display and array of exclusive features such as Alarm Memory, Ventilate Instruction, Quiet Self Test and Environmental Sensing, the FA3322X4 offers the highest level of CO detection for your home. All alarms are calibrated and rigorously tested in-house and are third party tested to receive the BSI Kitemark certification to provide peace of mind. Also, the new range is compliant with the revised European Standard EN 50291-1:2018 to ensure maximum protection. FA3322X4: Carbon Monoxide Alarm with digital display and 10 year batteryHowever, if your CO alarm is beeping, flashing red or not responding during a test, follow our troubleshooting guide to decipher the cause. This guide applies to FireAngel FA3313 and FA3820 alarms. Why is my FireAngel CO alarm going off?

The advice below is purely provided for ‘best practice’ and should not be used independently. Please note, these alarms are not suitable for homes in Scotland under the new Fire & CO regulations. The alarm comes with 2 X AA batteries that can be replaced once the low battery chirp can be heard. Experience both audible and visual safety warnings with the digital screen, which will change colour to indicate different incident types for clear safety advice.Combined smoke & CO alarms or mains-powered CO alarms are typically installed on the ceiling and should be at least 30cm away from any wall, light fitting, or other obstruction.